Sweep
New member
- Joined
- Dec 29, 2014
- Location
- Peterborough - UK
Instead of faffing around tapping the block (which looks to be a PITA) can I just machine a little bung for the original place and then just weld a port onto the sump?
Hello Guest, welcome to the initial stages of our new platform!
You can find some additional information about where we are in the process of migrating the board and setting up our new software here
Thank you for being a part of our community!
Instead of faffing around tapping the block (which looks to be a PITA) can I just machine a little bung for the original place and then just weld a port onto the sump?
Instead of faffing around tapping the block (which looks to be a PITA) can I just machine a little bung for the original place and then just weld a port onto the sump?
Is your motor already a FT motor. You could do yoshifabs or I offer a nice solution as well with no tapping involved
http://www.stsmachininginc.com/products/8-an-volvo-240-740-940-b21ft-b230ft-oil-drain-adapter