• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

1994 volvo 940 megasquirt?

Catsby

New member
Joined
Jan 5, 2020
Location
East Coast
Any comprehensive guides out there on using a megasquirt in a 94' 940? I just picked up the car, not entirely sure which ignition system it has on it yet but im willing to do a conversion. Would love some advice.
 
Only if it is a 945 and has a manual trans, otherwise crush it.


A Megasquirt has an ignition system built in, it just needs coil(s).

Why are you wanting to Squirt it?
This is usually only done if boost is added to a non-turbo car or alternative fuels are used or if the horsepower is increased well over stock.
 
Last edited:
If the 940 is a turbo model then it has LH 2.4 and EZK. If it is n/a then you will need to determine if it is a Federal spec car or Cali spec (LH 2.4/EZK or Rex/Regina).

Why are you wanting to MS the car? how much experiance do you have when it comes to cars? MS is not hard to wire into a car but it is also not for a beginner but not to say it isn't a good time to learn.

If you want to wire up a MS the key would be getting the wiring diagram and then determine if you want to keep the stock wiring harness and just make a PNP setup near the stock ECU or if you want to build a new stand alone harness.
 
Back
Top